Gram: RAZON,
E-mail: razonengg@usa.net, Website: www.razonengg.com
2.
Toughcrete powder is specifically meant to increase wear resistance of
concrete.
3.
For concrete flooring of say 5 inches lay 3” to
4” of concrete as usual, use Toughcrete-P105 10% of cement in the final
2”– 1” of the concrete to bring it to final finish thickness of 5”. This
duplexing must be done when the initial layer of 3” to 4” is still green,
and must be a wet on wet process. Level surface as usual and water cure for 21
days.
4.
Method of mixing: Mix dry aggregates as usual, add
Toughcrete-P105 5% - 10% of cement, mix thoroughly, use our Super Plasticizer
200 ml per bag of cement and water cement ratio not above 0.45 to obtain best
result.
5.
Toughcrete-P105 is manufactured under most
stringently monitored manufacturing process parameters to yield highest standard
final product. The abrasion resistance of the flooring increases 10-15 fold by
using Toughcrete-P105 and results will be consistent.
6.
The abrasion resistance of the flooring is
increased 10-15 fold by using Toughcrete-P105 powder. Very high abrasion
resistance & strength combination is obtained if Toughcrete-P105 and Super
Plasticizer combination is used. Use of Super Plasticizer is recommended since
it makes possible least cement & optimum strength combination considering
the fact that high cement content lead to higher heat of hydration &
associated disadvantages & concrete defects.
7.
Toughcrete-P105 powder is most useful for factory
flooring, garages flooring, car parking, run-ways, highways etc or any concrete
surface which requires high abrasion resistance.
Packing : 25
kgs and 50 kgs polylined bags.
|
Toughcrete-P105 |
Abrasion
test wear in mm |
Concrete
type |
Surface
micro cracks |
28 days
cube strength |
|
Nil |
2mm |
M-20 |
Seen |
35N/mm sq. |
|
8% |
0.15mm |
M-20 |
Not seen |
42N/mm sq. |
|
NO |
PROPERTY |
PERFORMANCE |
|
1 |
Colour |
Greyish |
|
2 |
Specific
gravity |
5 – 6 |
|
3 |
pH |
---- |
|
4 |
Dosage |
5% to 10%
to the weight of cement in upper concrete layer only. |
|
5 |
Packing |
50 Kgs. |
|
6 |
Storage /
life |
Use within
2 – 3 years, protect bags against tearing & store in cold dry place. |
|
7 |
Toxicity |
Nil |
|
8 |
Corrosion |
Nil |
|
9 |
Cement
Compatibility |
OPC or PPC |
|
10 |
Test
Report |
Available |
OTHER PRODUCTS:
Coatings:
1)
Rubberised Instant Water Proofer 2)
White Water Proofer
3) Damp Proofer
4)
Polyurethane Coating
5) Clear Water Proofer
6) Coal
Tar Epoxy
Sealents:
1) Crack
Seal
2) Rubberised Sealents
3) Insta Set
-600
Admixtures:
1) Super
Plasticizers 2) Accelerators
3) Retardex 4) Integral Water Proofer
5) Intrair
A.E.A.
6) Master Plaster
7) Rapid Grout
8) Anchorex
9) Hycrete RJ- 608
10) Block Maker 11) Toughcrete
12) Brick Master 13) Tile
Master 14) Pipe Master
15) SLP
16) PL-256
17) Block Master
Other Products:
1)
Strextra NSG -110
2) P.A.Bound
3) P.A.Mortar
4) Shutter Coat
5)
Floor Repairs Mortars 6)
RZ-ED Mortar 7) Special
Grouting system 8) Tile Fix
#1
9)
Tile Joint Sealer
10) Instant Plugging Mortars 12)
Easy Grout
13) Pipe Joint Sealer
Attention:
It is strongly recommended that site trials be conducted using site conditions and available raw materials to evaluate the product. Since site materials and conditions are beyond our control and since above suggestions and recommendations are based on our site trials and laboratory product evaluation & trials, and since methods of use at site are beyond our control. Hence, no guarantee is either implied or enforceable