660,
Taboot Street, P.O.Box 49, Pune 411001 [India] Ph: 6130791,
Telefax: 020-6130017
Gram: RAZON, E-mail:razonengg@usa.net, Website: www.razonengg.com
Fresh
concreting over old set concrete fails to develop good bound due to
differential thermal properties of old set concrete and fresh wet concrete.
This handicap can be overcome by
using our P.A. Bound.
P.A. Bound
comprises of factory packed containers of calculated quantity of resin
& hardner , and
is in
ready to
use form.
It is
of brushable consistency
, hence application is fast and
economical.
The
surface, which is to receive
P.A. Bound, must be free of oil and grease. Remove all
dust, loose
material by stripping or
scrubbing with wire brush. If the surface is smooth,
hack the
surface. Ensure
surface is
free of algae, fungus before coating the surface
with P.A. Bound. Avoid
applying a thick coat. Pot life after mixing resin and hardner is 1 – 1½
hour.
P.A. Bound should be applied
over completely
dry surface.
Do not pour cement slurry
over P.A. Bound coated
surface. Directly pour concrete on tacky P.A. Bound coat.
Freshly prepared mortar may now be
applied when the P.A. Bound coat is still tacky.
Packings:
½ kg, 1 kg, 5 kgs. (Resin Plus Hardner)
|
NO |
PROPERTY |
PERFORMANCE |
|
1 |
Colour |
Hardner:
Clear Amber coloured fluid. Resin
: Clear liquid. |
|
2 |
Pot
life |
1
– 1 ½ hours after mixing. |
|
3 |
Shelf
life |
1
year. Unmixed containers should preferably be stored in cool dry place. |
|
4 |
Application |
Brush
application. |
|
5 |
Mix
ratio |
Empty
out entire contents of hardner into Resin. Stir well. Avoid beating-motion
else air entrapment leads to poor strength |
|
6 |
Typical
applications |
Old
concrete new concrete joints, basements, swimming pools, aqueducts, etc. |
|
7 |
Coverage |
5-10
sq. meter per kgs depending upon surface |
|
8 |
Bond
strength |
Greater
than 150 – 200 kgs/cm2. |
|
9 |
Precautions |
Apply
P.A.Bound over completely dry surface. The first pour of concrete may
preferably have water cement ratio 0.4 to 0.5. The fresh concrete must be
poured when the P.A.Bound coating is still tacky. |
OTHER PRODUCTS:
Coatings:
1)
Rubberised Instant Water Proofer 2)
White Water Proofer
3) Damp Proofer
4)
Polyurethane Coating
5) Clear Water Proofer
6) Coal Tar Epoxy
Sealents:
1) Crack
Seal
2) Rubberised Sealents
3) Insta Set 600
Admixtures:
1) Super
Plasticizers 2)
Accelerators 3)
Retardex
4) Integral Water Proofer
5) Intrair [A.E.A.]
6) Master Plaster 7) Rapid
Grout 8)
Anchorex
9)
Hycrete RJ- 608 10) Block
Maker 11)
Toughcrete 12) Brick
Master
14)
Pipe Master
15)
SLP
16) PL-256
17) Block Master
Other
Products:
1)
Strextra NSG -110 2)
P.A.Bound
3) P.A.Mortar
4) Shutter Coat
5)
Floor Repairs Mortars 6) RZ-ED
Mortar 7) Special Grouting system
8) Tile Fix #1
9) Tile Joint Sealer
10) Instant Plugging Mortars 12)
Easy Grout 13) Pipe Joint Sealer
14) P.A.Mortar Slurry
Attention:
It is strongly recommended that site trials be conducted using site
conditions and available raw materials to evaluate the product. Since site
materials and conditions are
beyond our control and since above suggestions and recommendations are
based on our site trials, laboratory product evaluation & trials, and since
methods of use iat site is beyond
ur control. Hence, no guarantee can either be implied or enforceable.